How to Use the Tirer Tyre Lever.
Maximum leverage. Minimal faff.
Compact. Strong. Designed to do the job when others can’t.
How to Use the Tirer Tyre Lever
Quick Steps: Using the Tirer Tyre Lever
Step 1: Fit the tyre by hand
Push the second tyre bead onto the rim (in the channel), working left and right from opposite the valve. Stop when it becomes too tight.
Step 2: Detach Tirer handle
Separate the handle from the main body to prepare for assembly.
Step 3: Assemble the Tirer
Snap the handle into the hinge pins on the tool body — it should move freely.
Step 4: Position the Tirer
Rest the rear edge on the rim. Hook the tip under the tyre bead.
Step 5: Roll the tyre over
Pull back gently to lever the bead over the rim. Repeat as needed.
Assembling the Tirer Tool:
Before using the Tirer, assemble the tool by attaching the handle to the hinge pins.
Follow the 3-step guide below to get started.
How to Use the Tirer Safely – DOsandDON’Ts
✅ DO |
|---|
Insert the curved tip under the tyre bead |
Use gentle leverage to roll the bead over |
Work in small sections along the tyre |
Only use for the tightest section |
❌ DON’T |
|---|
Don’t force, pry, or twist the lever harshly |
Don’t use Tirer on fully inflated tyres |
Don’t use on tyres wider than 45mm |
Don’t substitute Tirer for prying tools |
Works With – Compatibility Overview
Tirer is designed to work with a wide range of tyre and rim setups — especially where traditional levers fall short.
Compatible with:
- 650c & 700c wheels
- Road, gravel, and CX bikes
- Tubed or tubeless setups
- Tyres up to ~45mm wide
- Bead-tight, hard-to-fit tyres
- CO₂ or hand-pump inflation systems
